Available 11 files for Clevo 6200M
Select Files
Company
Clevo
Categories
Notebooks & Tablet PCs
Serie
Clevo 6xxx Series
Model
Clevo 6200M
Description
Toshiba CD-ROM and Sanyo, Teac DVD-ROM Drivers
Size Driver
401KB
File Name
cdvdriver.zip
Observations
This manual describes how to setup the device driver of TOSHIBA ATAPI
CD/DVD-ROM Drive.
This device driver is exclusive use of following TOSHIBA ATAPI CD/DVD-ROM
drives.
XM-5602B, XM-5702B, XM-6002B, XM-6102B, XM-6202B, XM-6302B
XM-1502B, XM-1602B, XM-2402B, XM-1702B, XM-1802B
SD-M1002, SD-M1102, SD-M1202
How to setup the CD-ROM device driver.
1. Copy CD/DVD-ROM device driver to the system disk.
2. Add the following line to CONFIG.SYS of the system disk.
LASTDRIVE=Z
DEVICE=
Company
Clevo
Categories
Notebooks & Tablet PCs
Serie
Clevo 6xxx Series
Model
Clevo 6200M
Description
Video In
Size Driver
42KB
File Name
videoin.exe
Observations
Chips and Technologies Inc.
AVI Capture drivers
Preliminary Production Release 1.0.0.0
Installation, Upgrade, Applications tested with etc at the end.
Rev 1.0.0.0
Jan 31, 1998
1. Limited sizes to 320x240. Earlier bigger sizes showed up but were not
supported.
2. Reports dropped frames by using the estimated framerate. Makes the AVI file
more synchronous even if no sound is present.
3. Fixed MSDOS Full Screen and dynamic mode change (3DMaze screen saver)
hang problem when AVI Capture driver is active.
4. Removed misleading display with no resources when installing.
Rev 0.0.0.3
Dec 5, 1997
1. Modified PCVideo.DLL to work with both SMBus and GPIO
2. Modified PCVideo.DLL to return error if VPM is using the Video Port.
3. Modified PCVideo.DLL to do different alignment for 554 and 555.
Rev 0.0.0.2
Nov 11, 1997
Initial release
To Install:
1. Go to the Control Panel from the Start menu (CTRL-ESC, Settings, Control
Panel), select Add New Hardware, Next, No (to windows searching for New
Hardware, since the decoder is on the GPIO pins, Windows will not
detect it), Sound Video and Game Controllers, Have Disk.
SMBus systems (Gateway 2000) do not need special GPIO settings.
The default settings are for GPIO 0 and 1. If your system has different
settings, edit the PCVideo.INI file to reflect the new settings for
GPIO_SDA and GPIO_SCL
To upgrade:
1. First remove the device from the Control Panel, System, Device Manager,
Sound Video and Game Controller, Chips and Technologies Video Capture.
Then install it again like described above.
This release has the following limitations
1. It does not use a VSync Interrupt due to lack of this in the Hardware
2. The frame rate is limited to 5 frames per second (320x240 8bpp, P150)
3. Tearing may be visible, especially if the capture is in 16/24bpp modes.
4. This conflicts with the VPM and only one can be active at a time,
either the VPM or the AVI Capture driver. The AVI Capture driver detects
if the video port is in use and returns an error.
5. Fails a couple of tests of the Microsoft WHQL Video Tests in 320x240.
No errors if reduce size.
6. Overwrites display memory momentarily in some apps when starting.
7. Does not support dynamic mode switching in Windows. Usually see corruption
or loss of overlay.
8. Supports formats upto 320x240 only.
9. Displays and "!" through the device in the Device Manager and reports that
the device is not working properly even though there is no problem.
Company
Clevo
Categories
Notebooks & Tablet PCs
Serie
Clevo 6xxx Series
Model
Clevo 6200M
Description
Flash BIOS utility
Version
R1.30
Size Driver
19KB
File Name
fur130.zip
Company
Clevo
Categories
Notebooks & Tablet PCs
Serie
Clevo 6xxx Series
Model
Clevo 6200M
Description
User Manual
Operating System
Manual
Size Driver
897KB
File Name
6200m_010.zip
Company
Clevo
Categories
Notebooks & Tablet PCs
Serie
Clevo 6xxx Series
Model
Clevo 6200M
Description
VGA
Operating System
Windows 3.1
Size Driver
810KB
File Name
vgaw31.exe
Observations
Chips & Technologies, Inc.
DR655xx Display Driver Package
Release Notes for Windows 3.X
=======================================================================
Revision: Version 1.3.6 , 6555X
Release Date: August 28, 1997
=======================================================================
1. Fixed D-532 , NTSC/PAL problem. When in NTSC/PAL display and
switching between FS DOS and DOS box , NTSC/PAL display was
losing sync.
2. Fixed D-510, Could not change resolution or color when displaying
on NTSC/PAL display.
3. Fixed OEM6555X.INF driver name mode messages that are viewed in
windows SETUP program.
=======================================================================
Revision: Version 1.3.5 , 6555X
Release Date: July 18, 1997
=======================================================================
1. Completed bug fix #410. The change described below actually
fixed the problem / area beneath the cursor when cursor was
forced to SW. However, when the cursor was dinamically changed
from HW to SW (such as NTSC or interlaced modes), the cursor
problem still exists. This fix is taking care of it.
WGA.ASM - ResetHiResMode.
2. Fixed forced hardware/software cursor support with video
BIOSs that return function 5F50h with DL[4] = 0 , drivers
check for panning bit. CURSOR.ASM , CC_CHANGEDISPLAY.
=======================================================================
Revision: Version 1.3.4 , 6555X
Release Date: July 02, 1997
=======================================================================
1. Bug fix #482 : 65555X , after booting windows from DOS with POPUP
enabled , cursor disappears. The cause was the POPUP 55X cursor
initialization code was not being called , instead 655545/548
POPUP cursor intailization code was called.
2. Bug fix #410 : Alt Tab in/from DOS FS corrupts area beneath the
cursor when SW cursor modes (65555 and intermitent).
WGA.ASM - In ResetHiResMode skip checking HW popup cursor and HW
cursor in offscreen memory for SW cursor. The bug occured because
the above code was redrawing the SW cursor when it was not needed.
The area beneath the cursor was beeing messed up by the EraseTail_10
algorithm in that particular instance. ResetHiResMode is called
when returining from DOS FS and is asyncronuous with the displayed
screen. Sometimes, the EraseTail_10 (whithin DrawCursor) would not
restore the proper save_screen for the SW cursor.
Company
Clevo
Categories
Notebooks & Tablet PCs
Serie
Clevo 6xxx Series
Model
Clevo 6200M
Description
VGA
Operating System
Windows 95
Size Driver
172KB
File Name
vgaw95.exe
Company
Clevo
Categories
Notebooks & Tablet PCs
Serie
Clevo 6xxx Series
Model
Clevo 6200M
Description
TEAC CD-224E-A CDROM Drivers
Operating System
Windows 95
Version
1.27q
Size Driver
655KB
File Name
teaccdr.exe
Observations
***** How to install the device driver under DOS environment *****
To operate TEAC CD-ROM,the device driver (TEAC_CDI.SYS) has to be installed
from INSTALLATION DISK came along with CD-ROM.
Please follow the instruction below.
1. Boot up the system and insert the INSTALLATION DISK into your floppy
disk drive.
2. At the DOS prompt,type "A:\INSTALL" then press enter. (If your floppy
disk drive is "A:")
3. Installation program will now start.Please follow the instructions on the
screen to complete the installation procedure.
4. When finish,remove the INSTALLATION DISK from the floppy disk drive then
REBOOT your system.
During system reboot,check for the following message to assure that
the driver was loaded properly.
MSCDEX Version 2.23
Copyright (C) Microsoft Corp. 1986-1993. All rights reserved.
Drive X: = Driver TEAC-CDI unit 0
* 'X:' ... Drive letter assigned to CD-ROM Drive
This message means that TEAC CD-ROM drive is now activated.
* Now the installation of TEAC CD-ROMdrive is completed.
***** TEAC CD-ROM DRIVE Trouble Shooting Tips *****
------------------------------------------------------------------------------
Q1: System will not boot when CD-ROM drive is daisy-chained with
hard disk drive.
------------------------------------------------------------------------------
A1: Be sure your hard disk drive jumper is set to MASTER and CD-ROM's to SLAVE.
Please refer to the installation manual for CD-ROM jumper setting and ask
hard drive manufacturer for MASTER jumper setting.
Note: There may be a case where CD-ROM can not be daisy-chained with
Conner hard drive (Conner mode).
A2: Check if the I/F cable is connected reversely.
------------------------------------------------------------------------------
Q2: System hangs without displaying anything when the device driver is loaded
during Boot-up.
------------------------------------------------------------------------------
A1:There is a possibility that TEAC device driver is having a conflict with
others. Please check the position of the device driver statement or remark
driver which may be having a conflict with.
A2:In case that TEAC CD-ROM drive is connected with non TEAC CD-ROM drive in
the same system.
Please re-install the TEAC CD-ROM address by going through 'SELECT I/O PORT'.
Company
Clevo
Categories
Notebooks & Tablet PCs
Serie
Clevo 6xxx Series
Model
Clevo 6200M
Description
ALPS Touch Pad Drivers
Operating System
Windows 95
Version
4.1.0
Size Driver
379KB
File Name
alpsw95.exe
Observations
AlpsPoint provides a convenient way to modify setting for
Alps GlidePoint. The AlpsPoint drivers are compatible with
most standard mice and similar pointing devices.
____________________________________________________________
README FILE CONTENTS
1. Driver Installation
1.1 Installing from Mouse Properties
1.2 Installing from Device Manager
2. Using the AlpsPoint Control Panel
3 Restoring Your Installation
3.1 If "Alps GlidePoint" can be seen in the model column
3.2 If "Alps GlidePoint" can't be seen in the model column
4. Using Another Mouse
4.1 How to attach the Serial mouse
4.2 How to attach the PS/2 mouse
5. Troubleshooting
5.1 Suspend/Resume
5.2 Installing from Add New Hardware
6. Files On The Setup Disk
Company
Clevo
Categories
Notebooks & Tablet PCs
Serie
Clevo 6xxx Series
Model
Clevo 6200M
Description
OTHERS
Operating System
Windows 95-98
Size Driver
4KB
File Name
3mfddw9x.zip
Company
Clevo
Categories
Notebooks & Tablet PCs
Serie
Clevo 6xxx Series
Model
Clevo 6200M
Description
ESS1879 Audio Drivers
Operating System
Windows 95-98
Size Driver
658KB
File Name
ess1879.exe
Company
Clevo
Categories
Notebooks & Tablet PCs
Serie
Clevo 6xxx Series
Model
Clevo 6200M
Description
ALPS Touch Pad Drivers
Operating System
Windows NT
Version
1.02
Size Driver
154KB
File Name
alpswnt.exe
Observations
ApointNT provides a convenient way to modify setting for
Alps GlidePoint. The ApointNT drivers are compatible with
most standard mice and similar pointing devices.
____________________________________________________________
README FILE CONTENTS
1. Driver Installation
1.1 Installing from Mouse Properties
2. Using the ApointNT Control Panel
3 Restoring Your Installation
3.1 If "Alps GlidePoint" can be seen in the model column
3.2 If "Alps GlidePoint" can't be seen in the model column
4. Using Another Mouse
4.1 How to attach the PS/2 mouse
5. Troubleshooting
6. Files On The Setup Disk
Access to Official Website Clevo
Welcome to the HelpDrivers, driver for printers.
Original files: In HelpDrivers, all drivers, manuals, BIOS, etc. are those originally provided by the official manufacturers. Click here to learn more
You can download by either clicking the 'Download' button. From the File Download window, verify that "Save" is selected and click OK.
Do not rename the file you're downloading, it may cause installation problems.