Available 3 files for Comtrol Hostess i-S 16
Select Files
Company
Comtrol
Categories
Networks Cards
Model
Comtrol Hostess i-S 16
Description
Hardware Installation
Information
Manual PDF
Operating System
Manual
Version
A
Size Driver
34KB
File Name
6235.pdf
Observations
Hardware Reference Card
Hostess i/S 16
Scope
This reference card discusses the following topics for the
Hostess i/S16 controller:
• Identification • Configuration
• Installation • Specifications
• Memory addresses • Troubleshooting and
• Warranty technical support
Note: You must write your own device driver, as Comtrol
does not supply one for this controller.
Installing the Controller
Use the following steps to install the controller.
Warning: Static electricity may damage the controller. When
touching the controller, wear a grounding strap.
Hold the controller only by its edges or the
mounting bracket.
1. Turn the power switch for the system unit to the OFF
position.
2. Remove the system unit cover.
3. Select a slot to install the controller.
4. Remove the expansion slot cover.
5. Partially assemble the mounting bracket, by inserting a
screw in the upper portion of the bracket.
Do not completely tighten the screw at this time. The
movable portion of the bracket must be able to swing
freely, because it is used to secure the interface ribbon
cable.
6. Insert the controller in the expansion slot, making sure
that it is properly seated. Repeat steps 3 through 6 for
each controller.
Once the controller or controllers are installed, refer to your
Interface Reference Card to attach the interface.
Company
Comtrol
Categories
Networks Cards
Model
Comtrol Hostess i-S 16
Description
RS-232 16-Port (DB25) interface box
Information
Manual PDF
Operating System
Manual
Version
A
Size Driver
24KB
File Name
6236.pdf
Observations
RS-232 16-Port (DB25) Interface Reference Card Hostess i/S 16
Scope
This reference card provides technical information for
the interface box that you purchased with your
Comtrol™ controller.
The default setting for the interface box is RS-232
synchronous mode.
Installing the Interface Box
Use the following procedure to install the interface
box:
1. Pull the interface box ribbon cable through the
controller’s expansion slot.
2. Plug the interface box ribbon cable into the
controller’s ribbon cable connectors.
To do this, snap J3 into connector P3 and snap J4
into connector P4.
3. Peel back the ribbon cable’s copper shielding and
position it against the inside of the mounting
bracket.
4. Clamp the copper shielding against the mounting
bracket by moving the adjustable portion of the
mounting bracket into place.
This provides a ground for the ribbon cable.
5. Secure the mounting bracket by inserting the
bottom screw.
6. Replace the system cover.
If you need pinout information for the ribbon cable
connector that attaches to the controller, see the
documentation that came with the controller.
Company
Comtrol
Categories
Networks Cards
Model
Comtrol Hostess i-S 16
Description
Diagnostic
Operating System
Manual
Version
4.10
Size Driver
28KB
File Name
6167.exe
Access to Official Website Comtrol
Welcome to the HelpDrivers, driver for printers.
Original files: In HelpDrivers, all drivers, manuals, BIOS, etc. are those originally provided by the official manufacturers. Click here to learn more
You can download by either clicking the 'Download' button. From the File Download window, verify that "Save" is selected and click OK.
Do not rename the file you're downloading, it may cause installation problems.