Available 1 files for Maxxtro MusRadio-PS2

Company

Maxxtro

Categories

Mouse & Keyboard & Other Input

Model

Maxxtro MusRadio-PS2

Description

Drivers

Operating System

Windows 95-98-NT-2000

Size Driver

1MB

File Name

musradio.zip

Observations

Note: This equipment has been tested and found to comply with the limits for
a CLASS B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and if not installed
and used in accordance with the instruction manual may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. if this
equipment does cause interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:

* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
* Consult the dealer or an experienced radio TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:

(1) this device may not cause harmful interference.

(2) this device must accept any interference received, including
interference that may cause undesired operation.
1. Hardware Installation
1-1.Installing a Serial Mouse
You must have a PC fitted with a serial port(COM1/COM2) in order to
install the mouse. Plug your mouse into the serial port.

1-2.Installing a Mouse with Mouse Port (PS/2) Connector
If you have a mouse with a round mouse port connector, you must turn off
the computer before connecting or disconnecting your mouse.

1-3.Installing a Combo Mouse
The Combo Mouse comes with a PS/2 (DIN 6) cable connector, together with
a PS/2 -> Serial (COM 9) port adapter.
Before plug your mouse into the computer, try to make sure what kind of
mouse port you have. If you have a PS/2 port, plug in the original PS/2
cable connector; if you have a Serial port, please connect the adapter
first to the cable, then plug into the Serial port.
1. Turn the computer off.
2. Locate an available 6-pin round port on your computer.
3. Insert the mouse connector into the round mouse port.
4. Start your computer.

1-4.Select and Set ID for Wireless Mouse
Plug in receiver connector to your computer to turn on LED indicator.
After pressing ID setting button at the bottom of receiver, the LED
lighting flashed, and it's ready for your further mouse ID setting:

Set one mouse ID out of four:
ID one: Press the ID defining button (at the mouse bottom)
ID two: Press command key and ID defining button simultaneously
ID three: Press Pup-up key and ID defining button simultaneously
ID four: Press wheel button and ID defining button simultaneously

After you select ID and send signal from mouse, the mouse receiver
will receive and automatically detect and correspond to mouse for the
working linkage.After you successfully finish ID setting, the LED
indicator of receiver is corresponding to every move of the working mouse
by confirming of lighting flash.
If you want to re-define the ID, you have to press ID setting button first
at the receiver bottom. Then, process mouse ID setting again.

*Please note: once you change the batteries, you will have to re-define
the ID as well.