Note: This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. if this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna. * Increase the separation between the equipment and receiver. * Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. * Consult the dealer or an experienced radio TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference.
(2) this device must accept any interference received, including interference that may cause undesired operation.
1. Hardware Installation 1-1.Installing a Serial Mouse You must have a PC fitted with a serial port(COM1/COM2) in order to install the mouse. Plug your mouse into the serial port.
1-2.Installing a Mouse with Mouse Port (PS/2) Connector If you have a mouse with a round mouse port connector, you must turn off the computer before connecting or disconnecting your mouse.
1-3.Installing a Combo Mouse The Combo Mouse comes with a PS/2 (DIN 6) cable connector, together with a PS/2 -> Serial (COM 9) port adapter. Before plug your mouse into the computer, try to make sure what kind of mouse port you have. If you have a PS/2 port, plug in the original PS/2 cable connector; if you have a Serial port, please connect the adapter first to the cable, then plug into the Serial port. 1. Turn the computer off. 2. Locate an available 6-pin round port on your computer. 3. Insert the mouse connector into the round mouse port. 4. Start your computer.