USB 2.0 Metal HUB with 4 ports, incl. DIN-RAIL Kit
DESCRIPTION & TECNICAL INFORMATION :
The EX-1163HM is a plug & play high-speed USB 2.0 metal hub for USB 1.1 and 2.0
ports. The EX-1163HM provides 4 ports for USB devices and 1 uplink port for PC. It
uses data transfer rates up to 480Mbit/s. The EX-1163HM design fully utilize the NEC
chipset, which represents the latest in high speed USB interface technology. It provides
a secure and very high data transfer on each single port. The power over the terminal
block provides a maximum of power on each USB port of 500mA if power supply with
sufficient capacity is connected via T-block. It is not possible to change the address or
IRQ settings manually, they will be obtained automatically by the system (BIOS) and
operating system. The EX-1163HM is IP30 compliant. A Din-Rail Kit is included in the
extent of delivery for installation in a 19” Rack.
HARDWARE INSTALLATION :
Because the designs of computers are different, only general installation instructions are
given. Please refer your computer’s reference manual whenever in doubt.
1. Connect the USB cable to the USB B Connector of the Hub.
2. Connect the power supply to the T-Block Connector of the Hub.
3. Now connect the other end from the USB cable ( A-Plug) to the A-Connector at
DRIVER INSTALLATION :
After the hardware installation OS will recognize the device automatically and install its
CHECK INSTALLED DRIVER:
Open as sample the >Device manager< . Now you should see at „USB Devices“ the
following new entrys: .
If you see this or a similar information the device is installed correctly.