Epson Stylus Photo 820 Inkjet Download Manual

Donít turn off the printer or interrupt ink chargingwhile the power light is flashing or youíll use upmore ink than necessary when you turn it back on.
1ink cartridges paper support printer
1 Unpack
1
Remove everything from the box.
2
4
4 Load Ink
1
Open the output tray andraise the printer cover.
Keep cartridges out of the reachof children.
3
3 Power On
1
Plug the printer into a grounded electrical outlet.
2
Press the power button to turn on the printer.
Donít turn on your computer yet.
Donít use an outlet controlled bya wall switch or timer. Never use apower strip switch to turn theprinter on or off; use only theprinterís power button.
You must install bothcartridges or the printerwonít work.ink cartridgereplacementbuttonpower buttonblack color
CD-ROM
2 Connect the Printer
2
Remove all the tape andpacking material.
4
Insert the paper supportinto its three slots.
2
Lift up the ink cartridge clamps.
3
Unpack the ink cartridges that came withyour printer and remove the yellow tape.
4
Tilt each cartridge toward you as you lower it. Make sure the tabs rest on the hooks.
5
Lower the clamps so they snap shut.
6
Press the ink cartridge replacement buttonand close the printer cover. You see the green power light flash and you hear the printermake noise. Wait until ink charging is finished
(the green power light stops flashing).
Donít place the cartridge tabsunder the hooks, or you maydamage the clamp when youclose it.
Start Here
EPSON Stylus

Photo 820
Start Here
Printer Basics
Turn over
1
2hooks
3
Peel off the tape beneath the coverand remove the insert.remove theinsert
Connect the printer to your computer using either a USB cable or parallel cable. Donít connect bothcables; you only need one or the other. Follow the instructions in the appropriate section below.
If You Have a USB Port
(Does not support Windows

95 or Windows NT

.)
1
Make sure the printer and computer are turned off.
2
Connect the square end of the USB cable to your printerís USB port.
3
Connect the flat end of the cable to any available USB port on your computer.
If You Have a PC Parallel Port
1
Make sure the printer and computer are turned off.
2
Connect the larger end of the parallel cable to your printerís parallel port.
Then secure it with the wire clips.
3
Connect the other end of the cable to your computerís parallel port and secure it as necessary.
5
5 Load Paper
1
2
3
1
Load some paper behind the tabsinside the edge guides.
2
Press in the locking tab on theleft edge guide and slide it snuglyagainst the edge of the paper stack.
3
Pull out the output tray extension.8 8 Print Now that youíve set up your printer, youíre ready to print. See your Printer Basics book for instructions. Or, double-click the EPSON Printer Information Center icon on your desktop. You see this screen. Click Reference Guide to view detailed information about your printer. Click Print Show to view helpful animations that show you how to print, load paper and ink, and solve basic problems. 7 7 Install Optional Programs 1 After you register your printer, close any open windows on your screen until you see the Main Menu. (If you donít see the Main Menu, open your CD-ROM window and double-click the EPSON icon.) 2 Click Install Photo Software. You see this screen: 3 Select the software you want, click Install, then follow the instructions on the screen. When installation is complete, close any open windows and click Back to return to the Main Menu. 4 Click Install Printer Movies and Manual and follow the instructions on the screen. When installation is complete, click Exit or Quit to return to the Main Menu. 5 Click Share Photos Online at EPSON PhotoCenter. You see this screen: 6 If you want to place a link to the EPSON PhotoCenter SM website on your desktop, click Add Icon. Click OK, then click Back to return to the Main Menu. 7 Click Exit, then remove the CD-ROM. EPSON and EPSON Stylus are registered trademarks of SEIKO EPSON CORPORATION. EPSON PhotoCenter is a service mark and EPSON Software is a trademark of Epson America, Inc. General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners. EPSON disclaims any and all rights in those marks. Copyright 2001 by Epson America, Inc. Printed on recycled paper. 12/01 Printed in USA CPD-12673R2 4014184-01 6 6 Install Software 1 When you see the Windows icons on your monitor, put the EPSON CD-ROM in your CD-ROM or DVD drive. 2 Double-click My Computer, double-click EPSON, then double-click EPSON. 3 Read the license agreement and click Agree. 4 At the Main Menu, click Install Printer Driver. The files are copied to your computer. 5 If you see this screen, make sure the printer is connected and turned on. Click Retry if necessary. More files are copied. 6 When the installation is complete, click OK. The EPSON Product Registration screen appears. 7 Register your printer as instructed. Now youíre ready to install optional programs. Go to section 7. Windows 95, 98, Me, NT, 2000 Make sure the printer is turned on, then turn on your computer. Macintosh OS 8.5.1 to 9.x If youíre using Macintosh OS X, see the Read This First booklet for instructions on installing and using the printer software with OS X. Make sure the printer is turned on, then turn on your Macintosh . 1 When you see your Macintosh icons, put the EPSON CD-ROM in your CD-ROM or DVD drive. 2 Double-click the EPSON CD-ROM icon, then double-click the EPSON icon. 3 Read the license agreement and click Agree. 4 At the Main Menu, click Install Printer Driver. 5 At the installer screen, click Install. 6 Follow the on-screen instructions to complete installation and restart your Macintosh. 7 After your Macintosh restarts, the EPSON Registration screen appears. Register your printer as instructed. 8 Open the Chooser, click the SP820 Series icon, click your USB port, and turn on background printing. 9 Close the Chooser. Now youíre ready to install optional programs. Go to section 7. If you see a screen like this Click Cancel. Then follow the steps below to install the printer software: 1 When you see the Windows icons on your monitor, put the EPSON CD-ROM in your CD-ROM or DVD drive. 2 If you see a screen asking What do you want Windows to do?, click Cancel. 3 Click Start, click My Computer, double-click EPSON, then double-click EPSON. 4 Read the license agreement and click Agree. 5 At the Main Menu, click Install Printer Driver. The printer files install. 6 If you see this screen, make sure the printer is connected and turned on. Click Retry if necessary. More files are copied. 7 When you see a message that the printer port has been set or setup is complete, click OK. The EPSON Product Registration screen appears. 8 Register your printer as instructed. Now youíre ready to install optional programs. Go to section 7. Windows XP Make sure the printer is turned on, then turn on your computer. If you see this screen Click Cancel. Then follow the steps below to install the printer software: EPSON Software Film Factory installs in several stages. If you install ArcSoft PhotoImpression, select No, I will restart my computer later at the last screen, if necessary.

TXT / PDF

Available 27 files for Stylus Photo 820 Inkjet View all >
HelpDrivers Since March 2000