HUB FireWire 1394A with 6 ports, Metal box
DESCRIPTION & TECNICAL INFORMATION :
The EX-6683 is a plug & play high-speed IEEE1394a hub for IEEE1394a and
IEEE1394b ports. The EX-6683 provides 5 ports for devices and 1 uplink port for PC. It
uses data transfer rates up to 400Mbit/s. The EX-6682 design fully utilize the TI chipset,
which represents the latest in high speed IEEE1394a interface technology. It provides a
secure and very high data transfer on each single port. Via the external power supply it
provides a maximum of power on each port. It is not possible to change the address or
IRQ settings manually, they will be obtained automatically by the system (BIOS) and
HARDWARE INSTALLATION :
Because the designs of computers are different, only general installation instructions are
given. Please refer your computerís reference manual whenever in doubt.
1. Connect the FireWire cable to the FireWire Connector of the Ex-6682.
2. Plug the included power supply into the 5V Connector of the EX-6682.
3. Now connect the other end from the FireWire cable to the port at your PC.
DRIVER INSTALLATION :
After the hardware installation Windows will recognize the EX-6682 automatically. A
driver is not necessary because the EX-6682 will be connected to a host controller. If
there are any Problems with the installation please check the driver from your host
CHECK INSTALLED DRIVER:
Because this device doesn't use any driver it is not necessary to check the installation.
For cleaning please use only a dry fluffless cloth and remove the dirt with gently pressure.
In the area of the connectors please make sure that no fibres from the cloth remain
in the connectors. Attention! Never use a moist or wet cloth for cleaning!