Eusso UCT6110-SC Download Manual

Bridge Media Converter
10/100Base-TX to 100Base-FX
TP-to-ST/SC/VF-45/MT-RJ
User's Manual (620-0132-000)
1. Overview
IEEE802.3/u Ethernet supports two types media for network connection such as 10/100Base-TX and 100Base-FX. The bridge media converter is designed with a switch controller and buffer memory that connects two types segments operation smoothly. This converter can be used as a standalone unit or as a slide-in module to the 19" converter rack(up to 10 units) for use at a central wiring closet.

3. Checklist
Before you start installing the Converter, verify that the package contains the following:
? The TP-Fiber Converter
? AC-DC Power Adapter
? This User's Manual
Please notify your sales representative immediately if any of the aforementioned items is missing or damaged.

4. Installing the Converter
For as a standalone unit:
? Verify the AC-DC adapter conforms to your country
AC power requirement and insert the power plug
? Connect the media cable for network connection
For as a slide-in unit:
? The slide-in Media Converter and Converter Rack should be supplied only from the same source, both Media Converter and Rack are built to match each other at dimensions, DC jack, DC receptacle and power safety
? Turn off the 19" converter rack power
? Ensure that there is no activity in the network
? Locate +5VDC power jack on converter back, carefully slide in and plug to 19" rack +5VDC power receptacle
? Connect the media cable for network connection
? Turn on the converter rack power, the Power LED will light up
Note for TP port cable connection:
a. Use the straight-through cable.
Cable pin-outs for RJ-45 jack 1, 2, 3, 6 to 1, 2, 3, 6
b. MPR(Default) : To a Switch or Hub
DTE : To a workstation, or
NIC(Network Interface Card)
(DTE pin-outs is crossover on board already)
Configure the MPR-DTE slide switch on the side panel for cable connection to a hub or NIC(Network Interface Card)
c. Be sure the proper wiring and the Link LED status

7. Cable Connection Parameter
100Base-X network allows 512-bit time delay between any two node stations in a collision domain. The overall bit-time of TP/Fiber wires and devices must be within 512 bit in a segment. You may use a switch to break up collision domain and extend the cabling distance.
• TP Cable Limitations: Cat.5 100m
8. DC Jack and AC-DC Power Adapter
The DC jack's central post is 2.5mm wide, it conforms to the
DC receptacle(2.5mm) on the 19-inch Converter Rack slot.
9. TP-Fiber Technical Specifications
• Standards : IEEE802.3u 100Base-TX/FX
• UTP Cable : Cat. 5 cable up to 100m
Fiber Cable :
50/125, 62.5/125, or 100/140?m multi-mode
8.3/125, 8.7/125, 9/125 or 10/125?m single-mode
• LED Indicators :
POWER, FX LNK/ACT, 100, TP LNK/ACT, FDX/COL

• Flow Control: IEEE802.3x compliant for full-duplex
Back pressure flow control for half-duplex
• Power Requirement : 1A@?5VDC
• Ambient Temperature : 0? to 50?C
• Humidity : 5% to 90%
• Dimensions : 26.2(H) ? 70.3(W) ? 94(D) mm

Note: Connecting to Router, Bridge, or Switch,
please refer to the device's Technical Manual.