EnGenius ECB-3500 Download Manual and Firmware

Available 2 files for ECB-3500
Company
EnGenius
Categories
Networks Cards
Model
EnGenius ECB-3500
Description
EnGenius Locator
Operating Systems
Firmware
Size Firmware
274Kb
File Name
engenius locator.zip
Info
1. Locator software allows user to monitor and modify device IP and reset to default without accessing firmware GUI webpage.

2. Locator software works with device firmware v1.0.37 or later.

3. Locator software works on the following models only:
- ECB3500
- EAP3660
- EOC1650
- EOC2610
- EOC5610
Company
EnGenius
Categories
Networks Cards
Model
EnGenius ECB-3500
Description
Quick Installation Guide
Operating Systems
Manual
Size Manual
80Kb
File Name
ecb3500 qig.pdf
Info
ECB3500 is a powerful, enhanced, enterprise level product that supports 7 multi-functions to operate for
every kind of working environment.
This is a Wireless high transmit output power and high data rate indoor
device which plays different roles of Access Point/ Client Bridge /
Repeater / WDS AP / WDS Bridge / Client Router / AP Router. It
operates seamlessly in the 2.4 GHz frequency spectrum supporting the
802.11b (2.4GHz, 11Mbps) and super high speed of 802.11g (2.4GHz,
108Mbps) wireless standards. It supports high output power level
settings, bandwidth selection, RSSI indicator and antenna diversity
which enable the best transmitting and receiving signal for traffic
communication.
The attractive design, high performance, and array of features make ECB3500 a suitable wireless
solution for your residence or office.
This Guide will assist you in setting up the device as quickly as possible and with the least effort.
Hardware Installation
1. Place the unit in an appropriate place after
conducting a site survey.
2. Plug one end of the Ethernet cable into the
RJ-45 port on the rear panel of the device and
another end into your PC/Notebook.
3. Insert the DC-inlet of the power adapter into
the port labeled “DC-IN” and the other end
into the power socket on the wall.
IP Address Configuration
The default IP address of the device is
192.168.1.1 (Access Point mode). In order to log
into this device, you must first configure the
TCP/IP settings of your PC/Notebook.
4. In the control panel, double click Network
Connections and then double click on the
connection of your Network Interface Card
(NIC). You will then see the following screen.
5. Select Internet Protocol (TCP/IP) and then
click on the Properties button. This will allow
you to configure the TCP/IP settings of your
PC/Notebook.
6. Select Use the following IP Address radio
button and then enter the IP address
(192.168.1.21) and subnet mask
(255.255.255.0). Ensure that the IP address
and subnet mask are on the same subnet as
the device.
7. Click on the OK button to close this window,
and once again to close LAN properties
window.
HelpDrivers Since March 2000