Aten IC-104S Download Drivers and Manual

Welcome to Serial Interface / PCI Card This latest version contains corrections to the last version and additions to the next version. You will find them listed below. Version History: V6.0.0 - Initial Release

?? INSTALLATION GUIDE FOR PCI SERIAL PORTS.......................................3
?? INSTALLATION GUIDE FOR PCI PARALLEL PORTS................................8

Welcome to Serial Interface / PCI Card This latest version contains corrections to the last version and additions to the next version. You will find them listed below. Version History: V6.0.0 - Initial Release

?? INSTALLATION GUIDE FOR PCI SERIAL PORTS.......................................3
?? INSTALLATION GUIDE FOR PCI PARALLEL PORTS................................8

Packing Checklist
This package contains:

1 IC-102S 2 Port PCI Card

1 CDROM (Hardware Guide and Software Driver)

1 User Manual
Overview
The IC-102S 2 port serial PCI card provides two 9 pin male
connectors for the attachment of standard serial interface
peripheral units. It comes equipped with two High-Speed
RS-232 standard serial interface ports. Each port has 32 Bytes
of FIFO storage capacity and can attain speeds of up to 921
Kbps. The IC-102S is also plug and play enabled and will
support: NT 4, 98/ME, Win 2000, XP and Linux.
Hardware Installation
1. Power off your computer.
2. Plug the card into any available PCI bus slot.
3. Connect your peripherals (printer, modem, scanner, etc.) to
the card’s serial ports.
4. Power on your computer.

Normally any serial and parallel I/O ports can be supported by BIOS call
services in DOS environment. However there are only support 4 serial ports
(3F8h,2F8h,3E8h,,2E8h) and 3 parallel ports (3BCh/378h/278h) are supported
by BIOS/DOS.

If the user has more than one PCI-Card in the Slots, the dos driver
pcidos.exe remap the first ports, that found on the PCI-Slots. If the user wish
to remap ports of another PCI-Card, the Cards in the slots must
changed.

In case the PCI serial and parallel ports are different from the
above configurations (e.g. I/O address or more than 4 serial ports / 3
parallel ports), they are not supported by BIOS/DOS directly. However some
applications (e.g. "PComm Plus" could support 8 serial ports and each I/O
address is settable) have their own driver, thus PCI cards could
work correctly.

The following procedures will instruct you to install PCI serial
and parallel port device driver for DOS and Windows 3.1

Serial/Parallel PCI Card Driver Version 6.000, 2004/02/26

Supported Operating Systems:
Windows 2000 (x86)
Windows XP (x86)
Windows Server 2003 (x86)

To install or update the driver, run setup.exe.

Serial/Parallel PCI Card Driver Version 6.001, 2005/02/15

Supported Operating Systems:
Windows 2000 (x86)
Windows XP (x86)
Windows Server 2003 (x86)

To install or update the driver, run setup.exe.

1. Support Windows 2000/XP/2003/Vista(32 bit) driver