Micronet SP150KGE Download Drivers

Available 1 files for SP150KGE
Company
Micronet
Categories
Fax & Modem & ISDN
Model
Micronet SP150KGE
Description
Drivers
Operating Systems
Windows 95-NT4
Size Driver
31Kb
File Name
sp150kg.zip
Info
PCMCIA FAX/Modem Installation Diskette Ver. 1.4

1. This diskette contains :

* README.TXT : This README file
* PC_CARD.INF : .INF file for both Windows 95 and NT 4.0
* MDMEN.EXE : Fax/Modem Enabler
* MODEM.INF : .INF file for Remote Access Service (RAS) of NT 3.51

2. How to install the modem for Windows 95

(1) Select "Driver from disk provided by hardware manufacturer" item
at the "New Hardware Found" window, when you plug the PCMCIA
Fax/Modem card into the PCMCIA slot of your Windows 95 system
at the first time.
(2) Input the path "A:\" to load the INF file.
(3) Press "OK" button.

3. How to install the modem for Windows NT 4.0

(1) Make sure the PCMCIA card is plugged into the PCMCIA slot.
(2) Start up the Windows NT 4.0.
(3) Double click the Modem Icon in "Control Panel" window.
(4) In "Install New Modem" window, press "Next" button to auto-detect
the modems in the system.
(5) Press "Change" button to change the modem type.
(6) Press "Have Disk..." button.
(7) Input path "A:\" and press "OK" button.
(8) Select a correct modem type e.g.,"PCMCIA 56Kbps FAX+Modem"
and then press "OK" to accept the modem type.
(9) Press "Finish" button.
4. FAX MODEM ENABLER

The enabler, MDMEN.EXE is used to initialize the modem when you are not
using Card Services. You can use the Enabler as DOS command or DOS driver.
It means that you can load the enabler from the DOS prompt or put it into the
AUTOEXEC.BAT or put it into the CONFIG.SYS to load it everytime you start your
computer.

MDMEN [/COM=m] [/IRQ=nn] [/SLT=n]

where
COM=m Specify the COM port number (m=1 -- 3). Default is 2.
IRQ=nn Specify the interrupt request number in decimal. Default is
4 for COM1, 3 for COM2, 4 for COM3, 3 for COM4.
SLT=n Specify the slot number the Fax/Modem card plugged.
Default is auto-detection.
5. TECHNICAL NOTES FOR ENABLER

(1) Most communication software follows the Interrupt settings and
I/O address settings as shown below:

IRQ Number I/O Address

COM1: 4 3F8
COM2: 3 2F8
COM3: 4 3E8
COM4: 3 2E8

(2) If you are using Windows 3.1X, you can change the IRQ under the
CONTROL PANEL - PORTS - ADVANCED dialog box. If you change the
COMPORT and IRQ under Windows, be sure that it matches the parameter
in the MDMEN.EXE.
HelpDrivers Since March 2000