Maxtech PNic3000 Updated Download Drivers

Available 1 files for PNic3000 Updated
Company
Maxtech
Categories
Fax & Modem & ISDN
Model
Maxtech PNic3000 Updated
Description
Drivers
Operating Systems
Windows 95
Size Driver
365Kb
File Name
pnic3v7.exe
Info
LAN/MODEM PCMCIA PC Card ReadMe File
****************************************

1. GENERAL

To use the LAN/MODEM PCMCIA PC Card, your system must be
equipped with the following:

* 3.5'' high-density(1.44MB) floppy diskette drive
* a PCMCIA PC Card Standard, Type II or Type III slot
* a hard disk drive
* IBM or Microsoft DOS version 5.0 or higher
* Ethernet network operation system workstation software compatible
with ODI or NDIS drivers
* For use with Card Services based on PCMCIA release 2.1 only:
4kB of system memory address space(the driver needs this space
to map in the PCMCIA configuration registers for the purpose of
performing the interrupt acknowledge routine)
* 32 bytes of I/O space on a 32 byte boundary(LAN)
* 16kB of system memory address space(the LAN contains a 16kB
buffer which is accessed by mapping it into the system's memory
address space using a technique knows as "shared memory")
* 8 bytes of I/O space on an 8 byte boundary(modem). Usually starts
at 0x3F8, 0x2F8, 0x3E8, or 0x2E8
* The Card and Socket Services MUST compliant to new PCMCIA February
1995 PC Card Standard
* The software enclosed in this disk does not yet support the hot
swapping feature
2. NETWORK INSTALLATION

< Workstation for NetWare DOS ODI Client >

Introduction:
-------------
This section describes the procedure to setup the NetWare v3.X , v4.X
workstation driver for LAN/MODEM PCMCIA PC Card.

Location of Driver: \NWCLIENT\PCMDF.COM

Sample Configuration Files:
---------------------------
STARTNET.BAT:
LSL
NESL
PCMDF
IPXODI
VLM

NET.CFG
LINK DRIVER PCMDF
PORT 300
INT 5
MEM D4000
FRAME ETHERNET_802.3

Setup Procedures for NetWare 3.11/3.12 Client :
-----------------------------------------------
Before you start with the installation process, make sure that
the adapter is properly installed and configured. Make sure that
your NetWare workstation operating system is properly installed.

1. Copy PCMDF.COM from the LAN/MODEM PCMCIA PC Card Diskette
subdirectory A:\NWCLIENT to your harddisk.

2. Create a batch file, or add to your STARTNET.BAT file the commands
listed above under STARTNET.BAT

3. Edit the NET.CFG file that you copied over. Edit the file per your
requirements (see examples above). If there are two frame types
listed, whichever frame type is listed first, that is the one that
the driver will load. See above for examples.
HelpDrivers Since March 2000