MagicRAM 93356LK 56K PC Card Lucent Download Drivers

Available 1 files for 93356LK 56K PC Card Lucent
Company
MagicRAM
Categories
Fax & Modem & ISDN
Model
MagicRAM 93356LK 56K PC Card Lucent
Description
Drivers
Operating Systems
Windows 95-98-NT-2000
Size Driver
101Kb
File Name
56lk.exe
Info
TABLE OF CONTENTS :

1.0 INTRODUCTION

2.0 COMPLETE AT COMMAND SET

3.0 FAX MODEM POINT ENABLER

4.0 TECHNICAL NOTES FOR POINT ENABLER

5.0 ADDENDUM
1.0 INTRODUCTION

The installation of this fax/modem is very simple if you follow the
instructions carefully. The manual will provide most of the installation
instructions for various operating systems. Please refer to the ADDENDUM
section of this README.TXT file to view additional information not available
at the time the manual went to press.

2.0 DETAILED AT COMMAND SET

In the manual you will find a Basic AT Command Set. If you are looking for a
command that is not covered in the Basic AT Command Set you will need to
refer to the detailed AT Command Set for your particular modem.

To determine which file you should use with your modem, turn the modem over
and look on the top of the back label. The number on the top of the label
will match one of the .TXT files on this disk.

For instance:

FM144C, FM144D - CIR144.TXT
FM336SK, FM560SK - CIRRUS.TXT
FM288T, FM288M, FM336XT - ATT.TXT
FM288LK, FM336LK, FM560LK - LUCENT.TXT
FM144INT, FM288INT, FM288B,
FM336INT, FM336C, FM560RK - ROCKWELL.TXT

The .TXT file has information about your particular modem as well as a
Detailed AT Command set.

3.0 FAX MODEM POINT ENABLER

The DOS point enabler, PMXFM.EXE is used to initialize the modem when you
are not using Card & Socket Services. You can only use the Point Enabler
under DOS. DO NOT use this point enabler with any other operating system,
such as Windows 95 or Windows NT.

PMXFM [H|?] [F] [S=n] [M=xxxx] [C=n] [I=nn]

where
H or ? requests this menu
F force the Fax/Modem to be configured as specified
S specifies socket (0,1)
M specifies memory window segment
C specifies COM port (1,2,3,4)
I specifies interrupt requrest (IRQ) level
n is a decimal digit
x is a hexadecimal digit

The F and M switches are normally not necessary, unless card services
exists and users have trouble configuring the DataLink Card
through the card service.

Switches are not case sensitive.

Defaults:
S=first M=D000 C=4 I=3

4.0 TECHNICAL NOTES FOR POINT ENABLER
HelpDrivers Since March 2000