Harmony 18026 Download Drivers

Available 1 files for 18026
Company
Harmony
Categories
Fax & Modem & ISDN
Model
Harmony 18026
Description
Drivers
Operating Systems
Windows 95-98-98Se-NT4-2000
Size Driver
224Kb
File Name
hm18026.zip
Info
Table of Contens
i - FCC/DOC REQUIREMENTS
i.1 FCC General Information
i.2 FCC Notice
i.3 DOC Notice
1 - INTRODUCTION
2 - COMMAND REFERENCE
2.1 General Command Information
2.2 AT Commands
2.2.a Commands Preceded by &
2.2.b Commands Preceded by 2.2.c Commands Preceded by %
2.2.d Commands Preceded by -
2.2.e AT Commands Reference
2.2.f AT Commands for Testing and Debugging
2.3 Commands Not Preceded By AT
2.4 Result Codes
3 - S REGISTER REFERENCE
3.1 Register Summary
3.2 Glossary of the S Registers
4 - TROUBLESHOOTING GUIDE
5 - APPLICATION EXAMPLES
5.1 Dialing a Remote Modem
5.2 Dial a Stored Number
5.3 Manual Answer an Incoming Call
5.4 Auto Answer an Incoming Call
5.5 Voice to Data Switching
A - TECHNICAL SPECIFICATIONS
B - QUICK REFERENCE
C - HINTS FOR FAX SOFTWARE INSTALLATION
D - GLOSSARY
E - ASCII CODE TABLE
i - FCC/DOC REQUIREMENTS
i.1 FCC General Information
The Federal Communications Commission (FCC) of the United States restricts specific uses of modems,
and places registration responsibilities on both the manufacturer and the individual user:
1. The modem may not be connected to a party line or to a coin operated telephone.
2. The modem manufacturer must make any repairs to the modem to maintain valid FCC registration.
3. Notification to the telephone company is no longer required prior to connecting registered
equipment, but upon request from the telephone company, the user shall tell the telephone company
which line the equipment is connected to as well as the registration number and ringer equivalence
number of the registered protective circuitry. FCC information is printed on a label on the bottom of
the modem.
i.2 FCC Notice
This equipment has been tested and found to comply with the limits for a digital device, pursuant to
Subpart B of Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates and uses radio frequency
energy and if not installed and used the instructions, may cause interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try and correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a curcuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded interconnect cables and a shielded power cord must be employed with this equipment to insure
compliance with the pertinent RF emission limits governing this device. Changes or modifications not
expressly approved by the manufacturer could void the user's authority to operate this equipment.
NOTE : The manufacturer is not responsible for any radio or T.V. interference caused by
unauthorized modifications to this equipment. Such modifications could void the
user's authority to operate the equipment.
HelpDrivers Since March 2000