Diamond SupraExpress 56 Internal Speakerphone V.90 Download Firmware

Available 1 files for SupraExpress 56 Internal Speakerphone V.90
Fax & Modem & ISDN
Diamond SupraExpress 56 Internal Speakerphone V.90
Operating Systems
Windows 95-98-NT-firmware
Version Firmware
Size Firmware
File Name
SupraExpress 56 ACF 1 Meg External Series Windows 9x/NT firmware update.
Applicable files

V.90 and 56Flex (these updates allow you to update the modem to either 56Flex
or V.90):

supraexpress_56-209X_2200-firmware.exe (most current version V2.200-01)
supraexpress_56-209X_2081-firmware.exe (archive version V2.081-07)

(X is either a 1 or 2)

Release Notes
These firmware updates are provided for those who are experiencing difficulty with
their modem's current firmware. Unless you are experiencing connection or operation
difficulties with the modem, there should be no need to upgrade your firmware.
Firmware updates are created to deal with specific issues that may arise with
previous versions. In some cases, a firmware update may negatively affect the
situation. And for some modems there are no "flash-backs" to the previous firmware
versions to correct this.

Connection rates of 42K and above are common 56K connections for most US phone lines.
If your modem is operating properly, but only connecting at these connection ranges,
Diamond/S3 would not recommend updating the firmware. This is because it is not likely
that a firmware/driver update will improve these connection speeds.

Before considering updating the firmware/drivers, you may want to first try the following:

1) Try various initialization strings suggested on our web site, www.s3.com.
2) Try dialing into another number. The situation may only be present when dialing into
a specific number's equipment.
3) Test the line quality with the AT&V1 command.

If the situation persists after trying the above, then it may be beneficial to update
the modem's firmware.

It is recommeded that you use the V2.200 version of the firmware unless specifically
instructed otherwise by Diamond/S3 technical support.

Installation Instructions
You should print this document for easy reference.

1. Download the file onto your hard drive or a floppy disk. In your browser, click on the
file name. Your browser should prompt as to where you would like save the file. You should
note the location (i.e. c:\windows\temp, a:\, etc).

2. When the download is complete, you should disconnect from the internet and close all
open programs.

3. You should then need to extract the files from the downloaded file. Click
Start\Run\Browse. Locate the downloaded file. It should be in the noted location from
step 1 above. Click OK and then OK again.

4. For the V2.200 version, click OK to the Introductory Self-extractor window.

5. A second Self-Extractor window should appear. "C:\WINDOWS\TEMP" should appear
in the Unzip To Folder window. This is the default location. If you want to change
this, enter the appropriate location. For most purposes it should not be necessary
to change this. Click on the Unzip button.

6. After the files have been extracted click OK to the "success" window and then
Close to exit the extractor program.
HelpDrivers Since March 2000