Fax & Modem & ISDN
Wireless-G ADSL2+ Modem Router Quick Installation Guide
Quick Installation Guide
1. How do I configure my DSL-2640R router without the CD, or check my Wireless Network Name (SSID) and Wireless Encryption Key?
Connect your PC to the router using an Ethernet cable.
Open a web browser and enter the address http://192.168.1.1
The default username is admin. The default password is also admin.
If you have changed the password and can not remember it, you will need to reset the router to the factory default setting (steps in question 2), which will set the password back to admin.
2. How do I reset my router to the factory default settings?
Ensure the router is powered on.
Press and hold the reset button on the back of the device for approximately 6-8 seconds.
The process would take about 30 seconds to complete.
Note: Resetting the router to the factory default will erase the current configuration settings. To reconfigure your settings, log into the router as outlined in question 1, then run the Setup Wizard.
3. How do I add a new wireless client or PC if I have forgotten my Wireless Network Name (SSID) or Wireless Encryption Key?
For every PC that needs to connect to the router wirelessly, you will need to ensure you use the same Wireless Network Name (SSID) and encryption key as the DSL router has.
Use the web based user interface (as described in question 1 above) to check or choose your wireless settings.
Make sure you take a note of the settings so that you can enter them into each wirelessly connected PC. D-Link has provided a handy sticker for you to note them down and attach to your router, or other location you find most convenient.
4. What can I do if my router is not working correctly?
The manual contains a full troubleshooting section and can be downloaded from the D-Link website (see below), however there are a few quick steps you can take to try and resolve any issues:
Check the LEDs on the front of the router. The Power, WLAN, DSL and Internet LED should be on. One or more of the LAN LED should flash.
Check that all the cables are firmly connected at both ends.
Power the router off for 20 seconds, and then power it back on.