InterAct PS-2 and Serial Mouse I-73800 Download Drivers

Available 1 files for PS-2 and Serial Mouse I-73800
Mouse & Keyboard & Other Input
InterAct PS-2 and Serial Mouse I-73800
Operating Systems
MS-Dos Windows 3.1-95-98-98Se-Me-NT4-2000-XP
Size Driver
File Name
Note: This equipment has been tested and found to comply with the limits for
a CLASS B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and if not installed
and used in accordance with the instruction manual may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. if this
equipment does cause interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following

* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
* Consult the dealer or an experienced radio TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:

(1) this device may not cause harmful interference.

(2) this device must accept any interference received, including
interference that may cause undesired operation.
1. Hardware Installation
1-1.Installing a Serial Mouse
You must have a PC fitted with a serial port(COM1/COM2) in order to
install the mouse. Plug your mouse into the serial port.

1-2.Installing a Mouse with Mouse Port (PS/2) Connector
If you have a mouse with a round mouse port connector, you must turn off
the computer before connecting or disconnecting your mouse.

1-3.Installing a Combo Mouse
The Combo Mouse comes with a PS/2 (DIN 6) cable connector, together with
a PS/2 -> Serial (COM 9) port adapter.
Before plug your mouse into the computer, try to make sure what kind of
mouse port you have. If you have a PS/2 port, plug in the original PS/2
cable connector; if you have a Serial port, please connect the adapter
first to the cable, then plug into the Serial port.
1. Turn the computer off.
2. Locate an available 6-pin round port on your computer.
3. Insert the mouse connector into the round mouse port.
4. Start your computer.

1-4.Installing a Bus Interface Board and Bus Mouse
If you have a bus mouse, you need to install the bus interface board into
your computer. Next you will need to connect the mouse to the bus port.

The Bus Interface Board Jumpers
The J1 J2 J3 J4 jumper controls interrupts in your system. Interrupt are
temporary breaks in the sequence of a program caused by various I/O
devices, such as keyboard, drawing devices, and printers. Generally, two
devices connected to the same computer cannot use the same interrupt. You
must specify a mouse interrupt that does not interfere with the other
devices connected to your computer. The jumper refer to interrupts in the
system (IRQs). If you should change the jumper. Cross out the positions
you cannot use due to the type or configuration of your system. Then
place the removable plastic hood on any position. The default setting is
HelpDrivers Since March 2000