Storage & Tape Backup
Buffalo HD-HTGL TeraStation
Quick Setup Guide
The setup of Link Navigator is performed using the following steps:
Insert the TeraNavigator
CD into the PC’s CDROM
on the PC’s confi guration,
the EasySetup program
may launch. If it does
not automatically launch,
manually launch it by
pressing the ‘Start’ menu
and selecting the ‘Run...’ option. When the ‘Run’ dialog opens, type
x:\easysetup.exe (where X is the drive letter of the CD-ROM drive).
Press ‘OK’ to continue.
Link Navigator is now running.
Please press the ‘Setup
TeraStation’ button, then press
the ‘Start’ button.
The setup options appears.
Follow these setup instructions.
Choose “Initial setup” from setup mode selection.
? Disk drive structure
There are four methods to configure disk drive structure. Select
Select this mode to use four 250GB hard drives individually.
Select this mode to combine four 250GB hard drives as a one 1TB
Mirroring Mode RAID 1 (250GB×2)
Two pairs are created from the 4 drives as two separate 250 GB
shares. Data stored on each pair is mirrored automatically to the drive it
is paired with. Therefore, should a single drive fail, data is not lost as it
is also located on the mirrored drive of the pair. Drive replacement and
rebuilding of the Mirror should occur as soon as possible though. After
setting this mode, file transfer speed becomes slow down temporarily
flashing DIAG lamp.