Available 1 files for Micronet SP2500KWS

Company

Micronet

Categories

Networks Cards

Model

Micronet SP2500KWS

Description

Drivers

Operating System

Windows 3.11-95-NT

Size Driver

840KB

File Name

sp2500k.zip

Observations

Micronet SP2500K 10/100 PCI FAST ETHERNET ADAPTER
===================
How to Configure Your PCI adapter
---------------------------------
1. Go to the PCI configuration item in BIOS setup.
2. Take the following steps to configure the PCI slot:
a). You should know which slot your adapter is plugged into.
Look for the physical location of the slot on your PCI
motherboard.
b). Set the "this device" field to "Enable".
c). Set the "this item" field to "Master".
The Micronet SP2500K PCI adapter MUST be installed
in an expansion slot that supports "Bus Master" mode.
Refer to your system documentation to determine which slots
support Bus Mastering.
d). Some BIOS Setups allow you to select which interrupt line
you can use. In this case, select "INT A" for the "this item" field.
e). Select an IRQ of your choice, make sure it does not conflict
with existing IRQs in use.
d). Select the "Trigger method" by which the IRQ is assigned or
routed to the PCI slot. Choose "level-trigger" option.
Multiple SP2500K PCI adapters can share the same PCI
interrupt and all must use INT A with level-trigger mode.

3. Run the diagnostic program found in the driver diskette.
If a problem arises during installation, contact your dealer for support.
Conflict with Microsoft EMM386
------------------------------

The PCI adapters can only function with the EMM386.exe memory manager
program version 4.49 or later. You can verify its version number by
entering EMM386 at the DOS Prompt.

Do not specify the "highscan" option with the EMM386.exe statement
in your config.sys file or your system will hang.

If you run MEMMAKER and select Custom Setup, do not specify
"Aggressively scan upper memory", or it will automatically insert
the HIGHSCAN flag into the EMM386 command line. This parameter cannot
be manually removed once it's installed; doing so will cause the
extended memory manager to malfunction.
Support for 5 Volt PCI Slots
----------------------------

The Micronet SP2500K 10/100 PCI Fast Ethernet Adapter currently supports
only 5 volt PCI slots. Future release of the adapter will support both
3.3 and 5 volt PCI slots.
Note: 1. Some PCI-ISA computers require manual configuration. When you
set the interrupt you must move the jumper. For example,
if you set INT A to interrupt 5 via a BIOS configuration
setting, you must also set the jumper on your motherboard to ISA
interrupt 5.
2. Usually, the PCI machine supports only two Master Devices.
SCSI devices are also master devices.

*This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)this device must accept any interference received,
including interference that may cause undesired operation.

This Federal Communications Commission Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation.