D-Link DGE-530T Networks Cards > Downloads Drivers and Manual

Company

D-Link

Categories

Networks Cards

Model

D-Link DGE-530T

Description

32-Bit 10/100/1000 Base-T PCI Adapter Datasheet

Information

Manual

Operating System

Manual

Size Driver

435KB

File Name

dge-530t.pdf

Observations

10/100/1000Mbps Copper Gigabit PCI Card for PC
10/100/1000Mbps PCI Card

The DGE-530T is a 10/100/1000Mbps copper Gigabit PCI card for desktop PC. Installable in a PC equipped with PCI
expansion slots, this card turns a desktop computer into a high-bandwidth Gigabit workstation or a server running at
2000Mbps full-duplex speed.
High-performance Gigabit Speed
VLAN to Improve Performance and Security
Capable of running at full-duplex Gigabit speed, this card
gives your PC 2000Mbps data transmission on your existing
Cat. 5 twisted-pair network cable. As an inexpensive
alternative solution to fiber-optic, the card allows you to
instantly upgrade to Gigabit without requiring you to install
new, expensive fiber cables. The card supports
10/100/1000Mbps network speed auto-sensing and full/half
duplex auto-negotiation.
The card provides on-board screening of VLANs Tagged
Ethernet frames, allowing your PC to be configured with a
VLAN-supported switch. Your PC can be part of a VLAN
network, where domains are segmented up to enhance
performance and security.

Flow Control to Minimize Packet Loss
Small Form Factor, Lower Power Requirement
The card's embedded flow control and independent FIFO for
each port provide a means to protect against possible data loss
during transmission on the network. When connected to a
Gigabit switch Supporting flow control, the card receives
signals from the switch regarding buffer overrun during peak
usage periods. The card then delays transmission until the
switch is ready again to accept new data.
Using a single chip solution, this card is very small in size and
consumes very little power of your computer system.

Key Features
Copper Gigabit connection for PC
10/100/1000Mbps auto-sensing speeds
2000Mbps Gigabit full duplex support
32-bit Bus Master operation
Supports PCI clock speed at 33MHz
802.3x Flow Control for fast, reliable data transmission
Supports ACPI 2.0 WOL power management
Supports SNMP v.1
Supports 802.1Q VLAN Tagging *
PCI 2.2 plug-and-play
Universal bus 3.3V & 5V support
Runs Win98 SE, 2000, ME, NT, XP, NetWare, Linux, Unix
Very small size, very low power consumption

Company

D-Link

Categories

Networks Cards

Model

D-Link DGE-530T

Description

32-Bit 10/100/1000 Base-T PCI Adapter Driver

Operating System

Windows 2003

Size Driver

144KB

File Name

dge-530t_drv_win2003.zip

Observations

m4cxw2k3.txt created 10-Mar-2005

Readme File for M4CXW2K3.sys v7.42.1.3
D-Link DGE-530T Gigabit Ethernet Adapter

NDIS5.1 Miniport Driver for Windows XP and Server 2003 (x86)

This file contains
1 Overview
2 Required Files
3 Installation
3.1 Installing the driver
3.2 Updating the driver
4 Parameters

===========================================================================
1 Overview
===========

M4CXW2K3.sys is the NDIS5.1 32-bit Miniport driver.
***
2 Required Files
=================

To install the driver, the following files are required:
M4CXW2K3.sys NDIS5.1 Miniport driver
M4CXW2K3.inf installation setup script
M4CXW2K3.CAT digital signature (only if the driver is certified)
***

3 Installation
===============

3.1 Installing the driver
--------------------------

Read the installation instructions in the adapter manual carefully.
Follow these instructions to install the adapter in your computer.
Due to the plug & play facility, the operating system is able to find,
identify, and configure an adapter automatically.

If the adapter is not detected during installation by the operating system
the adapter is installed as "Ethernet Controller" under "Other Devices".
To install the driver you have to perform a driver update as described
in the next section.

Company

D-Link

Categories

Networks Cards

Model

D-Link DGE-530T

Description

32-Bit 10/100/1000 Base-T PCI Adapter Driver

Operating System

Windows 98-98Se-Me-2000-XP

Size Driver

869KB

File Name

dge-530t_drv.zip

Observations

D-Link DGE-530T Gigabit Ethernet 10/100/1000 Adapter

Contents
--------
- Introduction
- Getting Started
- Revision History
- Copyrights, Trademarks, and Disclaimers

Introduction
------------
Thank you for purchasing the D-Link DGE-530T Gigabit Ethernet adapter.
This CD-R driver support for the D-Link DGE-530T Gigabit Ethernet adapter
(support 10M/100M/1000M PCI).

This driver contains many kinds of Network Operating System
installation . Please refer to the readme file or user's guide
if any problems for installation, or please freely contact
our technical support.

You can get latest releases of drivers from D-Link's Web site
(http://www.dlink.com). We hope our new readmes and installations
will minimize the users effort to make our products work. Should there
be further recommendations please contact the support manager at the
local D-Link Office listed bellow.

Getting Started
---------------
Auto-run program assist your ease of setup. It will configure
driver, install appropriate network drivers for popular network
operating systems on the DGE-530T adapter.
You can operate some function through the friendly button:

1.View Manual(PDF): It will show detail manual for your reference.

2.View SNMP Manual(PDF): It will show SNMP manual of installation for your reference.

3.View Product Profile: You can find animation of D-Link product introduction.

4.Install Driver: It will configure driver, install appropriate network drivers
for popular network operating systems on the DGE-530T adapter.

5.Install SNMP Agent: It will install to the SNMP Agent for management.

6.Install Adobe Acrobat: You can install Adobe Acrobat Reader to read or
print out your user manual, and also many other applications.

7.Close: You can close Window by this button.

If the NOS (Network Operating System) you are using is not covered
by the auto-run program, please refer to the individual documentation
provided in each NOS directory.

Company

D-Link

Categories

Networks Cards

Model

D-Link DGE-530T

Description

32-Bit 10/100/1000 Base-T PCI Adapter Driver

Operating System

Windows Vista

Size Driver

274KB

File Name

dge-530t_drv_vista.zip

Observations

m4cxvista.txt created 10-Jan-2007

Readme File for M4CXVISTA.sys v9.15.2.3
D-Link Gigabit Ethernet Adapter

NDIS6.0 Miniport Driver for Windows Vista x86

This file contains
1 Overview
2 Required Files
3 Installation
3.1 Installing the driver
3.2 Updating the driver
4 Parameters

===================================================================
m4cxvst64.txt created 12-Jan-2007

Readme File for M4CXVST64.sys v9.15.2.3
D-Link Gigabit Ethernet Adapter

NDIS6.0 Miniport Driver for Windows Vista x64

This file contains
1 Overview
2 Required Files
3 Installation
3.1 Installing the driver
3.2 Updating the driver
4 Parameters

===========================================================================
1 Overview
===========

M4CXVST64.sys is the NDIS6.0 64-bit Miniport driver.
***
2 Required Files
=================

To install the driver, the following files are required:
M4CXVST64.sys NDIS6.0 Miniport driver
M4CXVST64.inf installation setup script
M4CXVST64.CAT digital signature (only if the driver is certified)
***

3 Installation
===============

3.1 Installing the driver
--------------------------

Read the installation instructions in the adapter manual carefully.
Follow these instructions to install the adapter in your computer.
Due to the plug & play facility, the operating system is able to find,
identify, and configure an adapter automatically.

If the adapter is not detected during installation by the operating system the
adapter is installed as "Ethernet Controller" under "Other Devices".
To install the driver you have to perform a driver update as described
in the next section.

Access to Official Website D-Link

Home English Home Spanish Home French Home German Drivers English Drivers Spanish Drivers French Drivers German

Welcome to the HelpDrivers, driver for printers.

Original files: In HelpDrivers, all drivers, manuals, BIOS, etc. are those originally provided by the official manufacturers. Click here to learn more

You can download by either clicking the 'Download' button. From the File Download window, verify that "Save" is selected and click OK.

Do not rename the file you're downloading, it may cause installation problems.

Available 8 files for D-Link DGE-530T

Select Files